免费av在线观看

 Ball screw manufacturer

News classification

Product classification

contact us

Name of Gaorun Machine Tool Co., Ltd

Contact person: Mr. Chen

Tel: 0513-83697868

Fax: 0513-83697868

Mobile phone: 13962731568

         18012236066

Email: ntgrjc @ 163.com

Address: No.8 Weizhi Road, 300m north of xiaohuaqu, Qidong City

Website: www.grntc

Friction torque testing machine designed by ball screw manufacturer

Your current location: home page >> News Center >> technical knowledge

Friction torque testing machine designed by ball screw manufacturer

Date of issue: 2019-08-08 Author: Click:

Each screw has a non abrasive part at the end. The section length is 200 mm. The friction torque can be dynamically monitored by testing machine. When the fluctuation of friction torque exceeds the range of test parameters, the nut is considered to be worn and will be replaced. When the grinding experiment is completed, clean the test screw and measure the change in travel, and then cut the screw to obtain sample fragments. The length of the sample is 80 mm. There are two sets of samples for each screw. One is from the grinding part and the other is from the non grinding part. These parts are used to measure the surface. The surface roughness of the debris from the non abrasive part will be used as reference data in subsequent analysis. There are two sets of samples for each screw. One is from the grinding part and the other is from the non grinding part. These components are used to measure surface roughness and residual stress. The surface force of debris from the non abrasive portion will be used as reference data in subsequent analysis. There are two sets of samples for each screw. One is from the grinding part and the other is from the non grinding part. The surface force of debris from the non abrasive portion will be used as reference data in subsequent analysis. Table 3 travel changes. In this study, an improved ball screw grinding is proposed. The tool is installed in the special Ball screw manufacturer On the designed friction torque testing machine. Compared with the traditional grinding method, the grinding time of this method is significantly shorter, and it takes ten minutes to obtain good grinding results. In addition, this grinding method is reliable because it does not rely on the experience and skills of the operator. This method can help to reduce labor cost and improve grinding efficiency. Different values of grinders will bring different grinding results.

 Ball screw manufacturer category

Website: http://zuiqiushi.com/news/1530.html

key word: Address of ball screw manufacturer , Ball screw manufacturer's telephone , Ball screw manufacturer Qidong

What's new:

Welcome to leave us a message
Please enter the message here, we will contact you as soon as possible.
full name
contacts
Telephone
Landline / mobile number
mailbox
mailbox
address
address